Englander Pellet Stove Auger Replacement: A Practical Guide

Replacing the auger in your Englander pellet stove is a straightforward yet essential task for ensuring the stove’s continued performance. In this article, we will provide clear and concise instructions for both technical and non-technical users on how to replace the auger in an Englander pellet stove.

The Auger: What Does It Do?

The auger is a critical component of a pellet stove. It’s responsible for transporting wood pellets from the hopper to the burn pot, where combustion occurs. If the auger becomes damaged or worn, it can lead to inconsistent pellet feed and a drop in stove efficiency.

Tools and Materials

Before you begin, gather the necessary tools and materials:

  • New auger (ensure it’s compatible with your specific Englander model)
  • Screwdriver
  • Wrench
  • Pliers
  • Work gloves
  • Safety goggles

Step-by-Step Auger Replacement

  1. Safety Precautions:

    • Ensure the stove is entirely cool before starting any work.
    • Disconnect the stove from the power source to prevent accidental activation.
    • Access the Auger Compartment:

      • Depending on your Englander model, access to the auger compartment may vary. Refer to your stove’s manual for precise instructions.
      • Empty the Hopper:

        • To minimize mess and weight, empty the hopper of any remaining wood pellets.
        • Locate the Auger:

          • The auger is typically found near the bottom of the hopper. You may need to remove some covers or panels to access it.
          • Disconnect the Auger Motor:

            • Carefully disconnect the wires from the auger motor, noting their positions for reassembly.
            • Remove the Auger:

              • Use a wrench or pliers to remove the bolts securing the auger to the motor shaft.
              • Unhook the Auger from the Burn Pot:

                • Depending on the design, you may need to unhook the auger from the burn pot assembly.
                • Install the New Auger:

                  • Position the new auger on the motor shaft and secure it with the bolts you removed earlier.
                  • Reconnect the Auger Motor:

                    • Reattach the wires to the auger motor, ensuring they match their original positions.
                    • Test the Auger:

                      • Reconnect the stove to the power source and turn it on. Observe the new auger’s operation to ensure it’s feeding pellets smoothly.
                      • Reassemble the Stove:

                        • Put back any covers or panels you removed to access the auger compartment.
                        • Refill the Hopper:

                          • Refill the hopper with fresh wood pellets, ready for use.

                          By following these steps, you can successfully replace the auger in your Englander pellet stove. Remember to refer to your stove’s manual for model-specific guidance and prioritize safety throughout the process. A properly functioning auger ensures efficient pellet feed, maintaining the stove’s performance and heating capabilities.

                          Leave a Reply

                          Your email address will not be published. Required fields are marked *