If you own a Breckwell pellet stove and find that your igniter is no longer working, you’re in the right place. In this concise guide, we will walk you through the essential steps to replace the igniter on your Breckwell pellet stove, ensuring that your stove continues to operate efficiently and provide reliable heat.
Before you begin, always remember to disconnect the power and allow your stove to cool down before performing any maintenance or replacement work.
Required Tools and Materials:
- Replacement igniter (specific to your Breckwell stove model)
- Screwdriver (typically Phillips or flathead)
- Needle-nose pliers
- Work gloves (for safety)
- Safety glasses
Steps to Replace the Igniter:
Disconnect Power: Ensure your Breckwell pellet stove is unplugged or disconnected from its power source. Safety should always be your top priority when working with any electrical components.
Access the Igniter: Open the stove door and locate the igniter. It’s typically positioned at the bottom of the burn pot and can be identified by the ceramic element extending into the burn pot. You may need to remove the burn pot or other parts to access the igniter, depending on your stove’s model.
Remove the Old Igniter: Using a screwdriver, carefully loosen and remove the screws securing the igniter in place. These screws may be located on the igniter itself or on the mounting bracket. Keep these screws as you will need them to attach the new igniter.
Detach Electrical Wires: Gently disconnect the electrical wires attached to the old igniter. These wires are usually connected using simple connectors or screws. Take note of which wire connects to which terminal for correct reattachment later. If necessary, use the needle-nose pliers to help remove the connectors.
Install the New Igniter: Take the new igniter and attach the electrical wires to the terminals in the same configuration as the old igniter. Ensure a secure connection to prevent any electrical issues.
Secure the New Igniter: Position the new igniter in the same location from which you removed the old one. Secure it in place by using the screws you removed earlier. Make sure it is snug but not overly tightened to avoid damage.
Reassemble the Stove: If you had to remove the burn pot or other components to access the igniter, carefully reassemble them as they were before.
Power On and Test: Reconnect the power to your Breckwell pellet stove and power it on. Test the igniter to ensure it’s functioning correctly. You should see the igniter element heating up and igniting the pellets in the burn pot.
Final Check: After confirming that the new igniter is working, do a final check to ensure there are no loose wires, and all components are properly in place. Your Breckwell pellet stove is now ready to provide efficient heat.
Conclusion
Replacing the igniter on your Breckwell pellet stove is a straightforward process, provided you follow the steps carefully and prioritize safety. By following this guide, you can ensure your stove continues to operate efficiently, keeping your space warm and comfortable during the colder months. Remember to consult your stove’s specific manual for any model-specific instructions or precautions.