The low burn air setting on an Englander pellet stove plays a crucial role in maintaining efficient and steady heat output while minimizing pellet consumption. In this guide, we’ll provide a clear and concise explanation of the low burn air setting, its importance, and how to correctly adjust it.
Understanding the Low Burn Air Setting
The low burn air setting on your Englander pellet stove is responsible for controlling the amount of combustion air allowed into the firebox during the low burn (minimum heat) operation. It’s an essential feature, as it affects both the heat output and fuel efficiency of your stove.
Importance of the Low Burn Air Setting
The low burn air setting is significant for several reasons:
Efficient Heat Output: Properly adjusting the low burn air setting ensures that your stove can operate efficiently at lower heat levels, making it suitable for maintaining a comfortable temperature during milder weather.
Fuel Conservation: By optimizing the low burn air setting, you can reduce pellet consumption. This helps save on fuel costs and extends the time between refills.
Minimized Emissions: A well-adjusted low burn air setting also minimizes emissions, making your stove environmentally friendly.
Adjusting the Low Burn Air Setting
Here’s how to correctly adjust the low burn air setting on your Englander pellet stove:
Access the Control Panel: Turn off the stove and allow it to cool down. Open the control panel, typically located on the front or side of the stove. Refer to your stove’s manual for specific instructions on accessing the control panel.
Locate the Low Burn Air Control: Inside the control panel, you’ll find the low burn air control. It’s often a knob or lever that can be adjusted.
Adjust the Setting: Start the stove and set it to the low burn mode. Gradually turn the low burn air control clockwise to decrease air intake or counterclockwise to increase air intake. Make small adjustments and observe how they affect the flame.
Observe the Flame: The goal is to achieve a steady, small flame with minimal flickering. A proper low burn setting should produce consistent heat without causing the flame to extinguish. If the flame goes out, you’ve reduced the air intake too much.
Fine-Tune as Needed: You may need to fine-tune the setting to achieve the desired heat output. Remember that the ideal setting can vary based on the pellet type, stove model, and your specific heating requirements.
Record Your Setting: Once you’ve found the optimal low burn air setting, it’s a good practice to record it, especially if you change pellet types or adjust the stove for seasonal variations.
Conclusion
Properly adjusting the low burn air setting on your Englander pellet stove is a simple yet effective way to optimize heat output, save on fuel costs, and reduce emissions. Regularly monitoring and fine-tuning this setting ensures your stove operates efficiently, maintaining a comfortable indoor temperature while minimizing pellet consumption. It’s an essential aspect of getting the most out of your pellet stove.